1 5

Max. 550C Heating Jacket and Temperature Controller with 12mm ID Si3N4 Pressing Die - HC-SiN-12

Max. 550C Heating Jacket and Temperature Controller with 12mm ID Si3N4 Pressing Die - HC-SiN-12

Minimum Order: $20 (equipment), $100 (crystals)

Shipping and handling will be applied

Low stock: 2 left

$1,975.00 USD
$1,975.00 USD
Sale Email for Lead Time

SKU:  HC12SiN

Die Size
View full details

EQ-HC-SiN is designed for heating 12mm I.D. Silicon Nitride Pellet Pressing Die with Heating jacket (550°C Max.) and Temperature Controller. Programmable Temperature Controller is standard from 03/09/2021.

SPECIFICATIONS: 

 Model HC12SiN HC20SiN
Structure





 		The 12mm SiN Heating Die Set includes:
  • A set of 12mm Silicon Nitride Pellet Pressing Die - Die-SiN
    • Die Sleeve: 30mm O.D. x 12mm I.D. x 40mm H
    • Upper Pushing Rod: 12mm Dia. x 40mm H
    • Lower Rod: 12mm Dia. x 10mm H
  • Mold Release Rod
  • Mold Release Sleeve
  • Upper and Lower Supporting Plate
  • Heat Insulation Plate with mica
  • Heating Jacket: 65mm O.D. x 40mm H
  • Copper Adapter: 39mm O.D. x 30mm I.D. x 40mm H
  • Single Set Point Temperature Controller - MTC1000
The 20mm SiN Heating Die Set includes:
  • A set of 20mm Silicon Nitride Pellet Pressing Die - Die-SiN
    • Pressing Die Sleeve: 40mm O.D. x 20mm I.D. x 40mm H
    • Upper Pushing Rod: 20mm Dia. x 40mm H
    • Lower Rod: 20mm Dia. x 10mm H
  • Mold Release Rod
  • Mold Release Sleeve
  • Upper and Lower Supporting Plate
  • Heat Insulation Plate with mica
  • Heating Jacket Ø58×Ø50×40 mm
  • Copper adapter Ø50×Ø40×40 mm 
  • Single Set Point Temperature Controller - MTC1000
Voltage
Power 
  • 550W
Working Temperature 
 and Pressure
  • Temperature: RT - 500 ºC 
  • Pressure: 100 MPa 
Temp. control method
Application Note
  • Please always wear protective goggles during the operation !!!
  • The heating and cooling temperature rate should be below 5 °C/min
  • The volume of feeding material should be below 1/3 total volume of Si3N4 sleeve. Over-feeding material may cause damage to the sleeve at high temperatures.
  • Suggest using 32~75 microns particles for pressing (Pic.1)
  • Please clean the mold after the completion of each experiment.

 

×

This product is a consumable product and all consumable products are NOT covered by MTI's warranty. Make sure to inspect for defect(s) thoroughly before use. 

Manufacturer Part Number: 

Related Products

Loading related products...