1 4

Split Dry Pressing Die for Ring Type Sample from 10 mm to 32.mm Dia. - Die-Ring-C

Split Dry Pressing Die for Ring Type Sample from 10 mm to 32.mm Dia. - Die-Ring-C

Price: RFQ

SKU: 

Choose Your Variant or Type in Any Add-Ons:



View full details

Die-Ring-C is a split-drying pressing die for making ring-type samples in the ID 5- 32.5 mm range and OD 10 - 58 mm.

SPECIFICATIONS:

Materials
  • Cr12MoV
  • Hardness: HRC 60
 Max. Load
  • 350 MPa
Pressing die installation schematic
     
Application Notes
  • To get the better density of samples, please considering using a cold isostatic press (CIP)
  • Small particles may slip into the gap between the pushing rod and steel sleeve and cause damages to the sleeve during the compression. We recommend using 32~75 microns powder to avoid damages.
  • Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to get 32~75 microns particles
  • Please use alcohol to clean the pressing die every time before and after use
  • Store it in a dry place with antirust oil after the operation to avoid rusting.
  • For pressing sticky metal powders such as Al, Mg, Zn, it is necessary to use dry or alcohol-based lubricant to lubricate the die and sleeve set to reduce friction during the compression. 
  • Please must always wear protective goggles during the operation !!!

Related Products

Pressing Die 1/8" - 3" 
Laboratory Mill & Mixer
Powder grinding & Mixing
Gravity Convection Ovens, Max. 300C

Drying Ovens

Calcining & Sintering

Hydraulic Press
CIP - Cold Isostatic Press

 

×

Dimension of Die:

  • ID:    20 - 35mm ( +/- 0.01 mm )
  • OD:   40 - 70mm
  • Height:   25 - 50 mm
  • The customer must provide the drawing of the ring-type sample with tolerance for quotation

This product is a consumable product and all consumable products are NOT covered by MTI's warranty. Make sure to inspect for defect(s) thoroughly before use. 

Manufacturer Part Number: