GSL-1200X-50B is a high-pressure tube furnace up to 1200oC @ 90 bars. The furnace consists of three-zone internal heating inside an SS310 air-tight chamber, which can accept various gases from inert to oxygen, such as Ar, N2, H2, Co, CO2, CH4, and O2.
The slideable explosion-proof case is built-in the outside heating vessel and the remote control is available via laptop computer
Specifications
|
Power
|
- 208- 240VAC, Single phase, 50/60Hz
- 5000W Max ( 30A breaker required)
- A 10-foot power cable is included without a plug
|
|
Vacuum chamber
|
- The vacuum chamber is made of 310S alloy with water cooling jacket
- Chamber size: OD 220x ID 170 x L 1200 (mm)
- Water cold flanges in the two ends are made of SS304 and are slidable
- KF40 vacuum port, gas inlet, and outlet, as well as valves, are included
- Sliding protection case is included
- 95 bar gas release valve is built in for safety
- 12- 9 channel gas delivery system is available upon request ( click Pic 1 to order)
- 16L/minute recirculating water chiller is required (Click Pic 2 to order
 Pic. 1  Pic. 2
|
|
Heating Chamber
|
- Three-zone heating chambers are located inside a vacuum chamber.
- Heating zone: OD120 x ID 50 x L340x3 (mm) Total heating length: 1020 mm
- Uniform temperature zone: ~ 450oC +/- 2oC
- One quartz tube (OD60 x ID50 mm) is inserted into the heating
- Heating element: FeCrAl resistance wire with YSZ coating
- Max. working temperature: 1200ºC
- Gas compatible: Inert gas, H2, CO, CH4 and O2
|
Temperature Control 
|
- 3 digital temperature controllers certified by MET and CE Certified
- PID automatic control with 30 programmable segments for control of heating & cooling rate and dwell time.
- Built-in overheating & broken thermocouple protection.
- Over-temperature protection and alarm allow for operation without attendant(s).
- +/- 1 ºC temperature accuracy.
- RS485 Communications Port and software are included for PC remote operation
|
|
Gas control (optional)
|
- Gas pressure and flow rate control is available upon request
|
|
Flammable Gas protection (optional)
|
- When using flammable gases in the tube furnace, one must install a flammable gas leak detector and cut off the gas supply in case of a gas leak (Pic. 1)
- Flammable gas shall be burned via an automatic burning device (Pic. 2)
- Without MTI training and permission, never use the furnace for flammable gases
|
|
Compliance
|
- CE certified
- NRTL or CSA certification is available upon request at the extra cost
|
Pic. 2
