GSL-1500X-10R is a high-pressure rotary tube furnace for inert gas flow at 10 Bar max up to 1500ºC. The alumina processing tube with 4.7" ID x 59"L is inserted into three zones of heated Moly coils which are built inside the SS 304 tube with 10" OD and vacuum flange. The explosion-proof case is built-in outside the vessel. The furnace is suitable for calcining powder under high pressure reduced inert gases or flowing CO2 gas for CO2 capture
Specifications
Power 
|
- 208 - 240V AC, single phase, 50/60Hz
- 15KW max
- > 75A breaker
- The power cable is included, but the power plug is not
|
Heating Chamber 
|
- The heating coil is made of 2 mm diameter Moly wire with 4.75" ID ( 120 mm) x 59" Length (1500 mm )
- Three Heating zone, each zone length is about 500 mm with independent temperature control.
- Constant temperature zone length: ~ 1000 mm within +/-5ºC
- The heating coil is surrounded by fibrous alumina for thermal insulation which is
- The heating element is built inside the SS304 tube with 240 mm OD x 10 mm thickness with vacuum-sealed flanges and gas inlet and outlet valves.
- The pained steel case is built outside tube for forced air cooling and explosion protection
|
|
Rotation & Tilting
|
- The tube furnace is rotary driven by an electric motor.
- The sliding ring technique is used to ensure the furnace heating during rotation.
- Rotation speed is adjustable at 0 - 10 RPM with forwarding and reverse
- The furnace can be tilted at 0 - 15º by the electric motor.
|
|
Material Feeding
|
- The automatic powder feeder is mounted on the tiltable furnace via a vacuum-sealed swivel assembly. (Pic 1)
- The proper connection ensures a uniform feeding rate and the tube rotation undisturbed under a controlled atmosphere. (Pic 2-3)
 
|
Temperature Control  
|
- Three programmable temperature controllers are installed with+/- 0.1ºC accuracy
- (Eurotherm 3000 temperature controller)
- Three S-type thermal couple is installed
- RS485 port is installed for connecting to the PC
- Brand-new Laptops and software are included.
|
|
Pressure Control
|
- A programmable digital pressure controller is installed, which allows you to set up gas pressure up to 10 bars with 30 segments.
- An overpressure valve is installed for protection
|
Gas Flow Control Optional 
|
- Two high-pressure MFCs are optional control gas flow/ One for gas inlet and one for gas out up to 10 Bar
- Gas flow accuracy: FS 0.02%
|
|
Compliance
|
- CE, CSA or NRTL certification is available upon request at the extra cost
|
