• AC110V, Single-phase, 50/60Hz, 800W
• AC200V is available upon request

• 0.50.8MPa compressed air or inert gas is required for the operation

• 250ºC Max. ( +/- 2 ºC) for the top and bottom sealing die. (We normally recommend 180-200ºC for pouch cell sealing)

• 0 ~ 90 seconds adjustable (5 ~ 6 seconds recommended)

• Cleaning with Argon gas and slightly positive pressure before vacuum standing can effectively remove oxygen content and improve the wetting and filtration effect at solid-solid and solid-liquid interfaces of electrodes.
• Cleaning cycle number: 0-90 adjustable
• Cleaning pressure: 0~0.8KPa adjustable

• Vacuum level: Max. not less than -95KPa (The vacuum degree can reach mTorr level by using a mechanical vacuum pump)
• Vacuum standing time: 0~900 seconds adjustable
• Vacuum pre-standing time: 0~90 seconds adjustable
• The vacuum pump is not included. Please click here to order at MTI.

• A PLC screen was used to set the sealing parameters and show the operation status.
• Inert gas port, compressive gas port, and vacuum ports are installed on the back panel
• You need an air compressor to operate (not included, please click Pic. 1 to order)
• You need an inert gas tank to purge the chamber(not included)
• The vacuum pump is required for final sealing (not included, please click Pic 2 to order)
• 
  Pic. 1 Pic. 2

• Max battery size: L100 x W100 x Thickness 12 ( mm)
• Heatable sealing blade: 250oC Max with precision digital temperature control
• Sealing width: 4 mm (The sealing width could be customizable)
• Sealing length: 100 mm Max.
• Sealing evenness: ≤ 0.02 mm overlapping precision of top and bottom sealing dies
• Sealing die type: Sealing blade with rubber buffer (soft-sealing)

• Pressure: 393N Max.
• Consumption: ~ 0.04 L compressed air per sealing
• Please use high-purity inert gasses (Ar or N2), when operating in the glove box. Using Air Compressor driven when operating outside the glove box.
• Please note that the air compressor is not included and is not recommended for use in the glove box.
• Attention: If a gas cylinder is used instead of an air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. 

Dimension

• Sealing Machine: 400 mm L x 330 mm W x 290 mm H (with cover open),  400 mm L x 285 mm W x 200 mm H (with standing support closed)
• Control Unit: 230 mm L x 230 mm W x 290 mm H
• It is easily transferred into the glovebox from the antechamber. 
• A flanged tube can be installed to transfer the wires to the glove box without any gas leaks, which is available at extra cost. 

                

• Sealing Machine: ~16kg
• Control Unit: ~9kg

• CE Certified
• NRTL Certification is available upon request at an extra cost