This is a pair of sealing flanges with a water-cooling jacket valve for OD 3.5" (89 mm diameter) processing tube. If you cannot use a ceramic block at both ends of the tube, you must use the water-cooling jacket to keep the flange cool (otherwise the silicone O-ring may get damaged)
SPECIFICATIONS
| Features |
- Made of Stainless Steel with double high-temperature silicone O-rings on the flange.
- Stainless steel needle valve with 1/4" barbed fitting.
12mm Push to Connect port for water tube.
- The assembly kit will seal one end of 89-91 mm ( 3.5") diameter ceramic and quartz tube.
- Vacuum meter is installed in one side of flange.
- You may choose left side, right side or a full set of the flange at product option bar
- Note: You may order Digital Temperature Controlled Recirculating Water Chiller with 16L / min Flow, to cool the flange and save water. ( click picture below right to order )
|
| Vacuum level |
|
| Warming |
- Must put a refractory tube block in front of the flange ( see picture below ) to avoid heat radiation melt silicone O-ring. Please click the picture below-center to order the block.
- Please do not over tighten the three hex screws on the flanges to avoid overpressure incidents. The recommended torque is 35~40 inch-lbs.
- For liability considerations, MTI does not recommend or endorse the use of any toxic, flammable or corrosive gases with our flange assemblies. Please contact us with any concerns.
|
Application Notes |
-
Max. furnace working temperature is 1100ºC without a thermal block
-
If furnace working temperature > 1100ºC, suggest you use a thermal block
-
Please always use a recirculating water chiller ( see related product below ) to save water and protect
|