KSL1200X-M-F is a muffle furnace with a 310S alloy chamber and a working temperature of 1100°C. The 9x9x10" refractory alloy chamber has a gas inlet and outlet which can remove bender or glue to prepare porous materials or fill inert gas for sintering oxygen-sensitive materials. The programmable temperature controller is separated from the furnace for safe operation.
SPECIFICATIONS
Heating Chamber
Size: 12" x 12" x 12" ( 304 x 304 x 304 mm)
Capacity: 27 liters
Heating element: Ni-Cr-Al wire inserted a high purity fibrous alumina
Three sides heating
Max. Temperature: 1200 °C
Refractory Alloy Chamber
310S alloy chamber with hinged type door is placed inside the heating chamber
Size: 9"x9"x10" ( 230x230 x 250 mm )
Capacity: ( ~13.2 Liter )
8 mm ID gas inlet tube is put to the back of the furnace
8 mm ID" gas outlet tube is connected to the top of the furnace
K type thermal couple is inserted into the inside chamber for temperature control
Max. working Temperature: 1000°C
Note:
This is not an airtight chamber, but it is enough to keep smoking leaking to damage the heating chamber
For air-sensitive material, suggest use 5%H2 + 95% Ar to keep the sample from oxidation
Power
208~240V AC, Single phase, 50/60 Hz
12.5KW
60 A Breaker (installed)
Note Power cable included, but without the plug. Please install a plug on your own
Max Operating Temperature
1000°C with refractory alloy chamber inside
1200 °C without refractory alloy chamber inside
Temperature Stability: ±1 °C
Suggested heating Rate: 10 °C/min
Temperature Controller
The FA-YD518P-AG temperature controller is included.
Proportional–integral–derivative control (PID control) and auto-tune function
30 segments programmed with ramping, cooling, and dwelling steps
Built-in over-temperature alarm and thermocouple failure alarm
+/- 1 ºC temperature control accuracy
Default DB9 PC communication port with PC operation software included
Eurotherm temperature controller with +/- 0.1 accuracies is available at the extra cost
Compliance
CE Certified
NRTL (UL61010) or CSA certification is available upon request at extra cost.
×
Net weight:
200 Kg
MTI offers a One-Year limited warranty with lifetime support(may cause a fee) for this product.
The MTI One Year Limited Warranty does NOT cover
Consumable parts such as Graphite dies, O-rings, crucibles, screws, washers, etc.
Any damage and rust resulting from improper storage or maintenance.
Any damages caused by the use of corrosive and acidic gases.
Any damage resulting from failing to adhere to the individual product's specific operation requirements, such as water cooling, venting, etc.
Manufacturer Part Number:
.
Choosing a selection results in a full page refresh.
